NO-Drill Car Spoiler Attachment System
This is a user-friendly
No-Drill line including some of today's most popular applications.
Installation is very simple with no drilling or fabrication. The
spoiler attaches to the trunk with 3M Automotive Grade Adhesive therefore no
drilling is required.
|
Step 1. Surface Cleaning
Clean
surface area that is to be covered by spoiler thoroughly with Isopropyl
Alcohol. |
 Step 2. Test Fitting the Unit
Before removing the tape backing, test fit the spoiler in order to get
comfortable with the placement. You can mark the position with a
grease pen or masking tape for a perfect fit. |
 Step 3. Preparation
Peel back the
corner of the red liner on the 3M tape and remove all pieces, avoid
touching the exposed tape. |
 Step 4. Installation
Gently press
the spoiler into place on the deck lid, hatch or rear glass. Once
satisfied with the placement, firmly press down on the spoiler to ensure
cohesion along the entire vehicle surface. Continue to apply
pressure or use masking tape to keep unit from lifting. |
Helpful Tips: Adhesive silicones and/or
adhesion promoters are often used in conjunction with provided 3M tape for
long lasting durability. For best results, installation should be
conducted in temperatures above 72º.
Refer to tape manufacturers recommendations for full details. Do not
clean, wash, wax or drive for 12 hours after installation.
CarData and Texas DAR are not responsible for no drill
attachment durability.
|
